Description/Introduction
The nucleic acid remover includes solution A and solution B. Both are non-toxic when either used alone or combined. After the two solutions are mixed in equal volume, it turns into a powerful nucleic acid degradation reagent, which can remove heavily contaminated nucleic acids (DNA or RNA) on most surfaces. This nucleic acid remover is designed for the removal of unwanted nucleic acid on molecular biology lab work benches.
Storage and Handling Conditions
Transport at room temperature. Store at 2-8℃ sealed for 8 months.
Component
| Component Number | Component | G3020-250ML | 3020-500ML |
| G3020-1 | Nucleic acid remover Solution A | 250 mL | 500 mL |
| G3020-2 | Nucleic acid remover Solution B | 250 mL | 500 mL |
Assay Protocol / Procedures
- Remove the reagent bottle cap and replace it with the spray head provided, the spray head can be switched on by twisting. When not in use, please turn the nozzle to "X" position, "……" position for straight spray; "shower icon" for multiple direction spray.
- Apply Spray solution A for the surface to be cleaned first, such as laboratory benches, biological safety cabinets, ultra-clean benches, instruments, plastic or glass containers, etc..
- Then immediately apply Spray solution B in the same area, and wait 5-10 minutes.
- Rinse the surface with distilled water, clean it with a paper towel.
- After use, the nozzle should be switched to off position ("X" ).
- Even though this product is safe to use, it is non-toxic, non-corrosive and non-irritating. We strongly suggest NOT spray directly to skin, eyes or mucous membranes. If skin contact is made, please rinse with water immediately.
- This product can only be used where the surface of the instrument and equipment can be wiped clean.
- For safety, please wear lab coats and disposable gloves when using.
Note: